|
|
Zeile 23: |
Zeile 23: |
| |} | | |} |
|
| |
|
| =Schütteltisch= | | =Schütteltisch (Wilfley table)= |
| ----
| |
| Mit einem [[Schütteltisch (Ausstattung)|Schütteltisch]] lässt sich Material aufgrund unterschiedlicher Form und Dichte separieren. Schütteltische werden ausgiebig für die Zirkonabscheidung zur U-Pb Datierung und die gewerbliche Abtrennung von Elementen mit hoher Dichte (z.B. Gold) verwendet.
| |
|
| |
|
|
| |
|
| [[File:Wilfley_table_methods_1.png|500px|thumb]] | | [[File:Wilfley_table_methods_1.png|350px|thumb|Schütteltisch in den Laboren der LMU.]] |
| ==Proben Verarbeitung==
| |
|
| |
|
| Nach der Justierung des Schütteltischs im benötigten Winkel und der Einstellung der Bewegungsgeschwindigkeit (Hubgeschwindigkeit, rpm), wird die Probe in den Vibrationsförderer gegeben der den Schütteltisch durch den Einspeisungskasten mit einer konstanten Rate speist (siehe Abbildung). Die Probe wird damit in drei Fraktionen geteilt:
| |
|
| |
|
| ====Schwere Fraktion====
| | [[Schütteltisch (Ausstattung)|Schütteltische]] werden dazu benutzt um leichte von schweren Partikeln zu trennen. Ursprünglich wurden sie entwickelt um Gold von leichterem Material zu trennen, heute werden sie auch zur Separation zahlreicher anderer Materialien verwendet. |
|
| |
|
| The heavy mineral fraction is concentrated in minerals such as zircon, garnet, apatite, sphene, monazite...
| | In einem kontinuierlichen Wasserstrom können unter Vibration des Tisches die auf dem Tisch platzierten Partikel bewegt werden. Hierbei kann das Wasser die Partikel über Rillen transportieren und so die Partikel nach ihrer Schwere aufteilen. |
|
| |
|
| Before proceeding to the picking of the desired mineral a magnetic separation is required to facilitate the picking.
| | Leichte Partikel werden dem Wasser über die Rillen folgen und können dann in Behältern an der Seite des Tisches aufgefangen werden. Schwere Partikel bleiben an den Rillen hängen und werden deshalb in Behälter am Ende des Tisches gelangen. |
|
| |
|
| If the heavy mineral fraction is still encumbered by lighter minerals such as quartz it is preferable to add a heavy liquid separation or a panning step to make the picking easier.
| | Mit dieser Methode können - je nach Größe und Konfiguration des Tisches - sehr große Mengen an Probe sehr schnell prozessiert werden. Der [[Schütteltisch (Ausstattung)|Schütteltisch]] in den Laboren der LMU kann bis zu 20 kg Probe pro Stunde auftrennen, industrielle Ausführungen schaffen bis zu 2500 kg Probe pro Stunde. Falls nur wenig Probe vorhanden ist sollte auf [[Panning|Panning]] zur Trennung von schweren und leichten Partikeln zurückgegriffen werden. |
|
| |
|
| ====Mittlere Fraktion====
| | Der Tisch kann auf unterschiedliche Arten eingestellt werden:<br> |
| | − Inklination des Tisches in langer Richtung, durch Anpassen der Kipphebel<br> |
| | − Neigung des Tisches in kurzer Richtung, durch Drehen des Rades<br> |
| | − Menge des Wasserflusses<br> |
|
| |
|
| The middle fraction is usually concentrated in minerals such as quartz, feldspars...
| | Je nach Probe sind unterschiedliche Einstellungen nötig um die gewünschte Sortierung zu erreichen. |
|
| |
|
| ====Leichte Fraktion==== | | ==Referenzen== |
|
| |
|
| The light fraction is usually concentrated with minerals such as micas and clays...
| | HolfmanWilfley.co.uk [online]. Available at: http://www.holmanwilfley.co.uk/shaking-table-products.htm, accessed 6 February 2019 |
|
| |
|
| ==Vorbereitung für das Verfahren== | | ==Weiterführende Literatur== |
|
| |
|
| • Turn on the wash water and ensure that the water is running evenly over the deck and is free of any dry patches. Start the machine and run for a few minutes on water only to wet all table edges.
| | Pita.ess.washington.edu [online]. Available at: https://pita.ess.washington.edu/rockprep/wp-content/uploads/sites/5/2017/04/Wilfley_manual.pdf [accessed 6 February 2019]. |
| | 911metalurgist.com [online]. Available at: https://www.911metallurgist.com/blog/wilfley-table [accessed 6 February 2019]. |
|
| |
|
| • Prepare the table feed by mixing the dry solids with water to give a 25% solids by weight mixture.
| | {{Autor|1=S. Stern, S. Prochaska, C. Nicolay, D. Aßbichler}} |
| | |
| • Place all sample buckets under the product off takes.
| |
| | |
| • The feed material will also respond better on the table if the feed has been sized beforehand so that all particles are in a narrow size particle band.
| |
| | |
| • This avoids coarse “lights” reporting with fine “heavies” (Stokes Law) and therefore gives better separating performance.
| |
| | |
| ==Table tilt== | |
| | |
| • The angle of tilt is adjusted by slackening the M16 nut at the drive connection (24mm Spanner). This will release the deck and it can be adjusted to the angle required (See figure).
| |
| | |
| • The correct slope can only be determined by visual inspection of separation. However, as a general rule, the greater the slope the cleaner the concentrate grade and lower the recovery and vice versa.
| |
| | |
| • The angle of the table from feed to concentrate end can be adjusted using the hand wheel located under the support beam at the concentrate end of the table (See figure). This angle can only be optimised by trial and error. However, the higher the concentrate end the longer the material remains on the table.
| |
| | |
| ==Wash water==
| |
| | |
| • The wash water which comes out from the wash sprays should flow evenly over the deck (see figure). The quantity of wash water can only be determined by experimentation. Higher wash water volume results in cleaner concentrates and lower recovery and vice versa.
| |
| | |
| ==Feed rate==
| |
| | |
| • Feed rate is a function of particle size and specific density differences between particles. This can vary from a few kgs/hour upwards. However, as a general rule, the finer and/or more close density the separation between particles the lower the feed rate will be. (Typical max. 70 kg/hour)
| |
| | |
| ==Reference==
| |
| | |
| Pita.ess.washington.edu. (2018). [online] Available at: https://pita.ess.washington.edu/rockprep/wp-content/uploads/sites/5/2017/04/Wilfley_manual.pdf [Accessed 23 Jun. 2018].
| |
|
| |
|
|
| |
|
| [[Kategorie:Probenaufbereitung nach Präparationsmethode]] | | [[Kategorie:Probenaufbereitung nach Präparationsmethode]] |